Stamping and forming processes
What is metal stamping?
Answer
What is the most common missing input in a drawn-part stack-up? A wall thickness, roundness or concentricity value has little meaning unless the drawing states the height, axial section and circumference where the value applies. The stack should follow those same measuring positions. Does a 0.01 mm tolerance apply to every deep drawn dimension?
Sources
- Tolerance Stack-Up in Deep Drawn Assemblies | BalfordWhat is the most common missing input in a drawn-part stack-up? The measurement location. A wall thickness, roundness or concentricity value has little meaning unless the drawing states the height, axial section and circumference where the value applies. The stack should follow those same measuring ...
- Tolerance Stack-Up in Deep Drawn Assemblies | BalfordA: RSS should be used only when its assumptions are supported by process data. A new part usually has no production distribution yet, so worst-case analysis is the safer contractual starting point. RSS can then be added after capability studies show that the contributors are independent and centered...
- Metal Stamping Guide | Process, Tooling & QuotationHome › Engineering data › Metal Stamping: How It Is Engineered and Quoted Engineering data · Process If you already know the process and need the supplier route instead, the custom metal stamping services page covers what to send and what comes back. Metal Stamping: How It Is Engine...
- IMDS Meaning: Material Data System for Automotive SuppliersPart family Typical material What the entry carries Sensor housing 304 / 316L stainless, DC04 Strip composition per heat from the mill certificate, final drawn mass, nickel or passivation layer Solenoid valve housing DC04, DT4E pure iron, 304 Magnetic grade as supplied, annealed condition, plating d...
- What Is Metal Stamping? Process, Types & Materials | BalfordWhat is metal stamping? Published: September 18, 2024 Metal Stamping: An Efficient and Versatile Manufacturing Technique Metal stamping is a core process in metalworking that's transformed how we produce components across virtually every industry. It works by feeding metal sheet or coil through a st...
- Metal Fabrication & Stamping Blog | BalfordDeep Drawn Stamping vs. Progressive Die Stamping: Process Selection for Precision Metal Components Summary Deep drawn stamping and progressive die stamping serve fundamentally different manufacturing needs. Deep drawing excels at… Read Article → Deep Draw Stamping Why Deep Drawn Aluminum Parts Work:...
What an engineer still needs from you
- material and material condition (grade, temper)
- material thickness, plus the key diameter, height and wall thickness
- tolerances, burr direction and the visual acceptance standard
- annual volume - it decides whether tooling is single-hit, progressive or transfer
- surface finish, and any secondary machining, annealing or plating
Need a DFM feasibility assessment for your project?
Send the engineering drawing (STEP or PDF) with the material grade, thickness and annual volume. Balford engineers then check it against the process window - draw ratio, wall thickness, tolerances, blank and tooling route - and come back with what is feasible and what is not. An answer on this page cannot replace that review.
Upload a drawing for DFM reviewHow the DFM review worksRelated questions
- Metal stamping vs casting vs machining: which process should I choose?
- What is the difference between blanking and piercing?
- What is bending and forming in sheet metal?
- What is coining and embossing in stamping?
- What is ironing in deep drawing and when is it used?
- What tolerances can metal stamping achieve?
This page is an engineering answer, not a quotation and not a dimensional acceptance. It is generated from Balford's published material and held to the verified company fact sheet.