Metal Ring for Rubber Bonded Metal Collar – DC01 Cold-Rolled Steel
What is this part? Metal Ring for Rubber Bonded Metal Collar is a Bushing manufactured from DC01 cold-rolled steel by Balford. Production process: Progressive Die Stamping → Surface Treatment. Finish: Zn-Ni plating. Key requirements: Tight bend radius for a secure rubber-to-metal bond; consistent ID/OD; good tube mouth roundness; reliable assembly alignment.
Deep Draw Metal Stamping
| Product Name | Metal Ring for Rubber Bonded Metal Collar |
|---|---|
| Category | Bushing |
| Process Flow | Progressive Die Stamping→Surface Treatment |
| Material | DC01 cold-rolled steel |
| Surface Treatment | Zn-Ni plating |
| Key requirements | Tight bend radius for a secure rubber-to-metal bond; consistent ID/OD; good tube mouth roundness; reliable assembly alignment |
Case Review
Tight bend radius for a secure rubber-to-metal bond. Consistent ID/OD, good tube mouth roundness, and reliable alignment during assembly. With rising cost pressure across the automotive supply chain, OEMs are tightening specs on metal parts to cut waste and improve throughput. Switching from machined to stamped parts under the same print requirements cut raw material usage and cycle time significantly.
