We build custom stamped metal components and brackets to your print. This particular bracket is for a date coder gun. If you need other configurations or hole patterns, send us your drawing and we'll quote it.
The metal frame requires precise hole alignment and protrusion placement. With 25 measurable characteristics and tight tolerances, holding consistency across the run was the main challenge—we dialed in the tooling to keep every dimension in spec.
Backing plate mounting plates for D-ring tie-downs, recessed style. Used in automotive, valve spring, and solenoid valve applications. Request a quote. The part is stamped from 4mm material, with the backing plate formed to sit flush in the recess.
The washer's center hole must align with the housing's center hole within tight limits. We hold over 95% bright band on the outer diameter and cutting edge, which keeps the shear zone consistent and the part flat for reliable assembly.
We use negative clearance between the die and punch to thin the material during the draw, which lets us hold both the outer and inner diameters within tolerance without secondary machining.
The housing surface must be free of draw lines, scratches, or embossing. We run vacuum annealing after forming to eliminate coercivity and keep the magnetic properties stable for the valve's proportional control.
Standard ferrule for solenoid valve applications across a wide range of configurations. The slotted design allows for consistent crimping without deformation. Finished with zinc plating for corrosion resistance in service.
Tight bend radius improves sealing contact with the rubber element. Inner and outer diameters are held to the same tolerance, with good roundness at the tube mouth for reliable alignment during assembly.
Stamped from 304 stainless steel at 1.4mm thickness to maintain structural integrity under load. Deburred on all edges, with the bend angle held to spec for proper engagement with the shaft nut.
Critical dimensions—inner and outer diameters plus overall height—are verified with a Go/no-go gauge to ensure fit. Surface finish is checked for defects that could affect coil seating or sealing.
Stainless steel housing that shields the solenoid coil from environmental exposure. Designed for direct installation on the methanol injection system's valve body, with tight tolerances on the mating surfaces.
Wall thickness is consistent between inner and outer diameters, and the top piercing appears machined due to tight edge quality. The flange face is flat and square to the bore for proper seating.
Saintbon Hydraulic and Hengli Hydraulic have contracted us to produce valve spring seats from AISI 1045 steel using a deep drawing process. This approach maintains grain flow for fatigue resistance in cyclic loading.
This stamped housing for an air suspension solenoid valve—also called a damping solenoid valve housing—requires tight control on concentricity and sealing surfaces to prevent air leakage under pressure.
