Pickling

Thin-wall aluminum deep-drawn parts are manufactured from a 0.8 mm 5052 aluminum disc run through multiple deep draw sta

These brass flat washers are used in solenoid valve assemblies. The parts shown are as-stamped, before pickling; after p

Balford builds custom coolant temperature sensor housings — including water temperature sensor housings and new energy v

This part is made from 4mm thick 6061 aluminum plate. We use blanking and stamping operations, and there's no post-stamp

The magnetic isolation sleeve for a solenoid valve is typically deep drawn from a stainless steel disc, 0.1–0.3 mm thick

The washer’s OD must seat tightly into the bore, with exhaust grooves punched on both faces. Top and bottom edges get ch

This stainless steel housing shields the solenoid coil and mounts directly on the methanol injection system's valve. The